Shop By make
0 items - $0.00
Ball Joint Assemblies
Cable Ties & Mounts
Chemicals & Sealers
Clamps, Hose & Tubing
Connectors, Nylon & Rubber
Couplings-Air Line & Acces.
Door Hinge Pins & Bushings
Drain Plugs And Gaskets
Drill Bits, Spot Weld, Saws, Cut Off Wheels
Gas Pump Accessories
Glass Shop Supplies
Grease Fittings, Guns, Accessories
Grommets & Grommet Material
Grommets, Nylon Screw
Headlight Adjusting Screw Assemblies
Hood Adjusting Nut & Bumper
Hood Insulation Retainers
Hoses, Rubber & Plastic
Keys & Accessories
Keys, Woodruff & Straight
Misc. Clips, Handles, Throttle Rod
Push Pull Controls
Retaining Rings, X-Washers
Rubber Hold Down Straps & Hooks
Sheet Metal Screws
Straps, Wire Harness
Tools & Accessories
Trunk/Vibration Dampening Pads
Vacuum Caps, Rubber & Vinyl
Wire Connectors & Terminals
Shop by Make
3/8"-16 U.S.S. Steel Nutsert
Usually Ships in 3 to 5 Business Days
The Auveco Nutsert was developed to offer both the production-oriented designer and engineer a unique and versatile anchor nut-type insert for high-speed installation. This Auveco system gives the designer the option to design for blind or open applications, eliminating and simplifying his design problems.
The Auveco Nutsert system provides a cost-saving method of installing clean, load-bearing steel threads in castings, fiberglass, fiberboard, plastics, wood or almost any ductile material more than .030" thick.
A simple hand tool installs the Nutsert...it is ready for use in seconds... no finishing is required after installation.
Auveco Nutsert's advanced design offers unlimited grip range in a minimum of sizes...inventory is minimized to one body dimension per thread Size; ideally suited for blind...buried... and through holes. The ingenious taper-lock principle locks-in the Nutsert preventing spin or twist; installs in flat or curved surfaces and is self-tightening with repeated use. The unique design of the installation tool eliminates marring of the parent material surface.
Material: Mild Steel, Cadmium Plated
Minimum Grip: .030"
To Set Nutserts Use Tool A11805 & Conversion Kits
Thread Size: 3/8"-16 U.S.S.
Recommended Nominal Hole Size: 9/16"
C: Diameters Vary With Material Density In Blind Application
D: Dependent Upon Material Thickness And Application
100 Per Package
View Catalog Page
Thinsheet Nutsert 8-32
Nutsert 3/8-16 Uss
6-32 U.S.S. Steel Nutsert
#10-32 Nutsert Tool Conversion Kit
(100) 5/16"-24 S.A.E. Steel Nutserts
Nutsert 8-32 Uss
Thinsheet Nutsert 6-32
Metric Thinsheet Nutsert M8-1.25
Share your knowledge of this product with other customers...
Be the first to write a review
Browse for more products in the same category as this item: