The Auveco Nutsert was developed to offer both the production-oriented designer and engineer a unique and versatile anchor nut-type insert for high-speed installation. This Auveco system gives the designer the option to design for blind or open applications, eliminating and simplifying his design problems.
The Auveco Nutsert system provides a cost-saving method of installing clean, load-bearing steel threads in castings, fiberglass, fiberboard, plastics, wood or almost any ductile material more than .030" thick.
A simple hand tool installs the Nutsert...it is ready for use in seconds... no finishing is required after installation.
Auveco Nutsert's advanced design offers unlimited grip range in a minimum of sizes...inventory is minimized to one body dimension per thread Size; ideally suited for blind...buried... and through holes. The ingenious taper-lock principle locks-in the Nutsert preventing spin or twist; installs in flat or curved surfaces and is self-tightening with repeated use. The unique design of the installation tool eliminates marring of the parent material surface.

Material: Mild Steel, Cadmium Plated

Minimum Grip: .030"

To Set Nutserts Use Tool A11805 & Conversion Kits

Thread Size: 5/16"-24 S.A.E.

Recommended Nominal Hole Size: 1/2"
Dimensions:

A: .499"

B: .524"

L: .305"

M: .610"

C: Diameters Vary With Material Density In Blind Application

D: Dependent Upon Material Thickness And Application

100 Per Package

View Catalog Page